Life-fitness T9I Bedienungsanleitung PDF herunterladen

M051-00K60-A032

Life Fitness Model 9000HR, 8500, and T9i Treadmills

How To... Replace the DC Controller E - Prom

Special Tools Required: None KIT: GK60-00002-0009

NOTE: Ground yourself by positioning the provided anti-static strap around your wrist and attaching the other end

(alligator clip or adhesive end) to a bare metal surface on the machine frame.

1. Turn the unit power OFF at the switch, and then unplug the line cord at

the wall outlet.

2. Remove four Phillips screws securing the motor cover to the frame.

Squeeze in the sides of the motor cover near the uprights so that the tab

on user’s left side clears the frame, and then lift off the motor cover.

3. Remove cable ties along the cross frame.

4. Remove four screws from the front of the unit and lift out the DC

Controller to access the wiring.

5. To ensure correct wiring locations, mark all wiring connectors at the back

of the DC Controller before making any disconnects. Once all wires are

tagged and identified, then disconnect connectors at the back of the DC

Controller Assembly.

6. Using Two small thin flat screw drivers and carefully remove the existing

e-prom as illustrated.

7. Carefully install the NEW e-prom ensuring all the leads are inserted

properly and not bent.

NOTE: The direction of the notch on the e-prom, matches the notch on

the circuit board.

8. Install DC Controller in reverse order, and replace all wire ties.

9. Turn the unit power OFF at the switch, and then unplug the line cord at

the wall outlet.

10. Remove the motor cover.

11. Disconnect RPM sensor cable and discard.

12. Install the provided OPTO bracket cable assembly as illustrated.

NOTE: Be sure the chopper wheel is centered within the opto sensor.

13. Inspect and test the drive belt and running belt for slipping. To tension the

drive belt, loosen the four motor mounting nuts, turn the tension bolt

clockwise and set the belt tension to 95 lbs and tighten the mounting

nuts.

If the running belt is loose, tension and track the belt as described in the

product Operation or Service Manual.

14. Carefully clean and vacuum the motor compartment.

15. Reinstall the motor cover.

16. Test the operation (Range of Incline, speed, Heart Rate) of each treadmill

to ensure proper operation.

OPTO Sensor / Bracket

Screws

DC Controller

Mounting Screws (4)

Main

Cable

Controller

OPTO Sensor / Bracket 1

Inhaltsverzeichnis

Seite 1 - OPTO Sensor / Bracket

M051-00K60-A032Life Fitness Model 9000HR, 8500, and T9i TreadmillsHow To... Replace the DC Controller E - PromSpecial Tools Required: None KIT: GK60-0

Weitere Dokumente für Sport und Erholung Life Fitness T9I

Um das Dokument anzuzeigen Life-fitness T9I Bedienungsanleitung

Life-fitness T9I Bedienungsanleitung (8 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Life-fitness T9I Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sport und Erholung Life-fitness T9I herunter. Life Fitness T9I User Manual Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Sport und Erholung Life Fitness T9I

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sport und Erholung Life-fitness T9I