15
STEP 18:
FIGURE18
9
36
37
• Slide two 5” ACCORIDIAN SLEEVES
(36) over the shafts on the PIVOT ARM
(9) as shown in FIGURE 18.
• Slide two PILLOW BLOCKS (37) over
the shafts on the PIVOT ARM (9) as
shown in FIGURE 18.
STEP 19:
FIGURE 19
• SECURELY assemble the PILLOW BLOCKS (37) on the PIVOT ARM (9) to the LEFT and RIGHT BOOM SUPPORTS (3 & 4)
using four 3/8 X 3” BUTTON HEAD BOLTS (72), four BLACK 3/8” SAE WASHERS (74), four RH WASHERS (76), four 3/8”
SAE WASHERS (75), four 3/8” LOW HEIGHT LOCK NUTS (73) and four RH CAPS (78) as shown in FIGURE 19.
• IMPORTANT! When PIVOT ARM (9) is centered and level in the PILLOW BLOCKS (37), tighten the PILLOW BLOCK set
screws.
• Slide two 1-3/8” OD COVER CAPS (35) over the ends of the shaft on the PIVOT ARM (9) as shown in FIGURE 19.
3/8 X 3” (76m) 72
BUTTON HEAD
73
78
76
35
75
74
9
4
3
37
0
1
1/2 1/2 1/2 1/2 1/2 1/2
23456
10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
Kommentare zu diesen Handbüchern